Model	UF-06A-I	UF-06A-II	UF-06AB-III
Working frequency	200-500KHZ	200-700KHZ	0.5-1.1MHz
Max input power	6.6KW	6.6KW	6KW
Max.input current	30A	30A	30A
Heating current	3-30A	3-30A	3-28A
Input voltage	220 V single-phase, 50/60Hz
Duty cycle	80%
Auto timer	0.1-99.9seconds
Waterpressure	≥ 0.2Mpa
Water flow	≥3L/min
Water temperature	<35°C
Generator size heating head size	520x260x450mm	520x260x450mm	520x260x450mm 140x93x140mm
N.W.	25KG	25KG	18/3.5kg
Packing size	690x385x630mm	690x385x630mm	690x385x760mm
Packing weight	48KG	48KG	52KG

With high frequency up to 1100KHZ the quenching thickness can be controlled lower than 1mm, and very thin and tiny parts can be easily heated.

MOSFET and current inverting technologies have been used; higher reliability and lower maintenance cost.

Constant current or constant power status can be selected accordingly to achieve higher heating efficiency;

Display of heating power and heating current and oscillating frequency.

Simple to install , installation can be done by unprofessional person very easily;

Light weight, small size;

different shape and size of induction coil can be changed easily to heat different parts.

Advantages of the model with timer: the power and the operating time of the heating period and the retain period can be preset respectively, to realize a simple heating curve, this model is suggested to use for batch production to improve the repeatability.

The separated small heating head is especially suitable for the applications in which the parts are stationary and the heating head is moved to fit the place.

Advantages and applications of models with timer function:

heating power, retaining power, heating time, retaining time can be preset and adjusted, this makes it possible to control the heating curve and heating time.

it is suitable to use in the repeated heating or high speed heating of small parts.

when using in brazing, with proper timing parameters, rapid heating and retaining can be achieved to keep the temperature while the brazing material is melted and then to let the brazing material spread smoothly to form good joint.

Advantages and applications of UF-06AB-III with heating head:

the heating head weight is 3.5KG, and size is 140 x 140 x 93mm, with 2 meters long cable between generator.

the light and small heating head is especially suitable for the applications in which the parts are stationary and the heating head is moved to fit the place.

brazing of hard alloy saw blade and machining tools.

heat treatment of small parts.

Quenching of the saw tip.

Shaping of the small driller.

Heating of wire smaller than 1mm.

fine steel wires (such as those used in dentistry) annealing.

small precision shaft quenching.

Floating melt for institute or college research and so on.